Even if youâve never completed more than rub the lint off the filter before, you might well be in a position to change a worn or damaged tumble dryer belt. A thumping sound or a drum that wonât change as the motor runs signifies a possible belt issue. The alternative procedure is simple, provided that the belt is properly rethreaded by you through the motor and idler pulleys. A new belt at around $7 to $15 for the component, while you provide the labor, makes trying the procedure worth while as compared to investing in a support call and waiting for the technician.
Unplug the dryer and pull it away from your wall. Remove the trap and unscrew the two screws holding the trap body to the very top of the dryer. Set the screws aside in a cup or can. Place your screw-driver involving the front panel close to the corners as well as the best panel of the washer and appear the top that is hinged.
Lift the top-panel, exposing the damaged or free belt in addition to the now-obvious drum. Remove the bolts, pushed by way of a lip on the side panels and below each corner, using a driver allowing one to slide the dryer entrance ahead. Set the nuts in a-cup.
While going to eliminate the assistance offered by the front-panel flange place a durable plastic-cup or mug near-by to be prepared to to slide beneath the drum. Therefore it leans ahead pull the front of the washer. Lift the entrance in the bottom off its clips and reserve. Hold up the drum as you have an assistant aid together with the drum or do this with your freehand. Slide mug or acup underneath the drum to to aid it.
Photograph or produce a sketch where it feeds through the idler pulley, underneath to the proper side of the drum, its particular path through the pulley stays noticeable and in the event the belt is worn but maybe not damaged. You can nevertheless loop its replacement in a S pattern round the motor and idler pulleys in the event the belt is broken. Remove the outdated belt.
Loop the belt that is new, ridged aspect touching the sleek facet noticeable or tracked, round the drum. Thread the belt through the idler pulley, which seems just like a white-plastic wheel on a steel arm, and loop it around the electric-motor pulley, which appears just like a post using a groove to to simply accept the belt.
Remove the cup and line the front-panel up and drum, using the assist of an assistant if existing. Nudge the entrance onto the clips together with the toe of your shoe. Replace and tighten the nuts in the most effective corners. Turn the drum manually to heart the alternative belt, feeling for the appropriate pressure from your idler pulley. Snap down leading until the clips engage and screw the lint protect screws straight back in. Re-Insert the lint cover. Plug in the dryer to check the drum turns with no noise.