Home

The best way to End a Chair Rail

Adding a chair-rail to other aspects of your home or your dining area produces a a vintage look. The ornamental trim enables you more versatility in your color-scheme, selecting wall-paper design or one-color over one and the chair rail under. It also serves a useful goal, scuffing the paint and maintaining chairs. Ending the chairrail — where it satisfies door or window trim for instance — needs a basic miter cut to produce a modification of the cut you’d use when turning another corner together with the chairrail, a miter or end cap.

Measure the amount of the wall and mark an item of chairrail 1/8 inch smaller for best-fit. Cut one end of the chair-rail using a miter saw at a 45-degree angle for connecting with the outside corner piece. In case you are finishing a an internal corner, cope the finish to satisfy another little bit of trim.

Miter cut the end of the chair-rail so the cut edge faces inward toward the extended edge as well as the wall is to the surface.

Nail the chair-rail in location utilizing 6d or 8d nails. Nail through bottom and the top of the chair-rail at least 1-inch in the edge to avoid splitting. Take a un-used nail and hold it in the chairrail between the hammer as well as a nail. Give a small faucet to counter sink the nail somewhat below the the top of chair-rail to it.

Miter cut the conclusion of a scrap bit of chairrail. Cut a little piece that’s as extended as the width of your chairrail to make what’s called a miter cap off. By way of example, in case your chairrail stands apart in the wall 2″, your last conclusion that is mitered should BE2 inches large. Cut the scrap trim like you had been shaping it to to show a an internal corner, with the cut-side facing toward the very front of the chairrail utilizing a 4 5-diploma mitered angle. That is called returning the trim on it self. The tiny piece is needed by you on the finish that outcomes from this cut. Be acutely careful when executing this cut to keep your handsfree of the blade of the miter saw’s. Use the guard to guide the short-end toward the blade of the saw and maintain only the long-end of the chair-rail for security.

The glue within the within of smear carpenter cut facet of the conclusion piece that is little. Glue it in location inside the chairrail that is nailed. Position it therefore that the exterior corners fall into line to to create a conclusion or a level, with regards to the type of chairrail you happen to be using. Tape the piece in location before the glue is totally dry, or using painter’s tape over-night.

See related